Patricia

Hardware Engineer, SEACOMP

Hi @Tom, The timing diagrams you're referring to are a bit misleading/not shown to scale.  The purpose of the second diagram you mention is to demonstrate that the Data Enable signal is us... (More)

Hi @Praveen  The module is mounted on a small PCB, with 4 mounting holes for use in your application. The board provides 16 through-hole contacts (pin 1-16) for access to the display signa... (More)

Hi @Uddhav P M  The maximum backlight voltage is 9.9V. (More)

Hi @Eswaran, This display has no P/S pin. The internal driver is hard-wired for parallel data, requiring no P/S selection on your part. The C86 pin (pin 3) is provided for MPU interface se... (More)

Hi @Simon Bonnenfant  Can you provide some more detail on your design/what you are interfacing with?  Have you switched out the display to verify whether the issue is related to the displa... (More)

Hi @Roy Shen, The INT035TFT module has a 45-pin connector, FH12-45S-0.5SH(55). It is listed as a recommended mating connector in the DT035BTFT display datasheet, here. However it is not lis... (More)

Hi @Feroze Mohamed, Could you provide some more information about your design (specifically the supply voltages) or perhaps share your schematic? What is your backlight voltage?  When you... (More)